Chevrolet Silverado: Bulb Replacement / Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

Chevrolet Silverado 2019-2026 Owners Manual / Vehicle Care / Bulb Replacement / Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

Base Level Taillamp Assembly

Stoplamp/Taillamp/Turn Signal Lamp
Back-Up Lamp
Side Marker Lamp

Uplevel Taillamp Assembly

1500 shown 2500/3500 similar

Back-Up Lamp

It is recommended to replace the grommets when replacing a bulb. See your dealer.

To replace one of these bulbs:

Open the tailgate.
Remove the two rear lamp assembly screws.
Pull the rear lamp assembly outward and rearward away from the box side to remove it from the vehicle.
Turn the bulb socket counterclockwise.
Pull the bulb straight out from the socket.
Replace the bulb and reverse Steps 1–5 to reinstall.

Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps

Base Level Headlamp Assembly Sidemarker lamp Low-Beam Headlamp High-Beam Headlamp Turn Signal/Park Lamps Midlevel Headlamp Assembly Turn Signal Lamps Headlamp Replacement Base Level Open the hood...

Center High-Mounted Stoplamp (CHMSL) and Cargo Lamp

This procedure is for the regular cab only. For crew cab and double cab see your dealer. Cargo Lamp Bulbs Center High-MountedStoplamp (CHMSL) Bulb To replace one of these bulbs: Remove the two screws and lift off the lamp assembly...

Other information:

Chevrolet Silverado 2019-2026 Owners Manual: OnStar

If the vehicle is equipped with OnStar and has an active service plan, additional data may be collected and transmitted through the OnStar system. This includes information about the vehicle’s operation; collisions involving the vehicle; the use of the vehicle and its features, including infotainment; and the location and approximate GPS speed of the vehicle...

Chevrolet Silverado 2019-2026 Owners Manual: Ignition Positions (Key Access)

0. Stopping the Engine/LOCK/OFF 1. ACC/ACCESSORY 2. ON/RUN 3. START The ignition switch has four positions. To shift out of P (Park), the ignition must be ON/RUN and the brake pedal must be applied. 0 (Stopping the Engine/LOCK/OFF) : This position turns off the vehicle...