Kia EV2: Light bulbs / Bulb replacement precautions

Working on the lights

Before you work on the lights, make sure the vehicle is in the OFF position in a safe place, firmly apply the parking brake, and turn the lights off to avoid sudden vehicle movement, which could cause finger burns or electric shock.

Light replacement

To prevent damage to the fuse or electric wiring system when you replace a light bulb, only use bulbs with the same wattage rating as the burned out bulb.

To prevent damage or fire, make sure light bulbs (and any parts used to secure them) you install are fully seated and locked. Failure to do so may result in heat damage, fire, or water entering the headlamp unit. Any of these results may damage the headlamps or cause condensation to build up on the lens.

Headlamp lens

To prevent damage, do not clean the headlamp lens with chemical solvents or strong detergents.

To prevent damage to the headlamp lens, do not clean it with chemical solvents or strong detergents.

After an accident or headlamp assembly reinstallation, have he headlight aiming adjusted by a professional workshop. Kia recommends visiting an authorised Kia dealer or service partner.

• If the light bulb or lamp connector is removed whilst the lamp is still on, the fuse box’s electronic system may log it as a malfunction. Therefore, a lamp malfunction incident may be recorded as a Diagnostic Trouble Code (DTC) in the fuse box.

• It is normal for an operating lamp to flicker momentarily due to a stabilization function of the vehicle’s electronic control device. If the lamp lights up normally after blinking momentarily, it is functioning as normal.

  However, if the lamp continues to flicker several times or turns off completely, there may be an error in the vehicle’s electronic control device. In this case, have your vehicle inspected by a professional workshop. Kia recommends visiting an authorised Kia dealer or service partner.

After you wash your vehicle or drive in the rain, you may find moisture inside the lamp lenses. This is normal condensation caused by the temperature difference between the inside and the outside of the lamp. It does not indicate a problem with the lamp’s functions. The moisture inside the lamp disappears if you drive the vehicle with the headlamps on. However, the level at which moisture dissipates may differ depending on the size, location, and condition of the lamp. If the moisture remains inside the lamp, have your vehicle inspected by a professional workshop. Kia recommends visiting an authorised Kia dealer or service partner.